Krag Collectors Association Forum

I have an extra marbles front sight blade if you want it just PM me with an address and I'll send it to you, no charge.

Front sight pin is easy to replace. Make a block of wood to support the sight base and drill a relief hole in it to accept the pin when you drive it out. Should be np, good luck.

Nancy Pelosi's list of political donors?

Nice job and nice save too! Hard to see from the picture angle but I have to ask, is that an after market "low scope" safety on it?

Nice looking sporter, appears to be a very high end professional conversion. I have dealt with those type swivels on other custom rifles. They work with a detent ball that is released when you press the center shaft in. In other words they are "quick detachable", problem seems to always be...

I've reloaded both and mainly use Remington, again due to availability. I do recommend neck sizing only since full length sizing is somewhat needless in a bolt gun. I neck size and trim every loading and have noticed no discernible difference between the cases. I load 150gr jacketed spitzer bullets ...

5mad good post and sound reasoning, IMO. I have fired a couple hundred Remington and 100 Winchester factory 180gr loads no problem and would do it again if necessary. I shoot my own reloads primarily for the enhanced accuracy, ability to reduce pressure and cost. I will echo the fact that I would ne...

It appears to be back now?

Looking forward to the pictures. Umatilla, OR, that brings back some memories for me back in the '90's when I did some MTT support for the NG on Bold Shift. Seems like I remember chucker hunting was good around there.

I don't think you can get hurt at that amount. Shoot it and enjoy it, a little TLC will keep it functioning for another 100.