S&K mount part 2
-
carbon outlaw
- Posts: 279
- Joined: Fri Jul 04, 2014 9:19 pm
S&K mount part 2
Got my scope mount finished ... I added a bracket so I could attached my S&K scope mount to the side plate ... I made the scope mount very solid ... Have a look ....
- Attachments
-
- DSCN0914.JPG (207.75 KiB) Viewed 1235 times
-
- DSCN0913.JPG (204.5 KiB) Viewed 1235 times
-
- DSCN0912.JPG (204.25 KiB) Viewed 1235 times
-
- DSCN0911.JPG (191.75 KiB) Viewed 1235 times
-
- DSCN0910.JPG (187.83 KiB) Viewed 1235 times
Re: S&K mount part 2
Nicely done. No gap evident here. Must have been an optical delusion or maybe an optical collusion that made me think a gap needed addressing. Should be the most stable S&K mount around!
-
butlersrangers
- Posts: 9860
- Joined: Wed Oct 07, 2009 11:35 pm
- Location: Below the Bridge, Michigan
Re: S&K mount part 2
Attractive on the outside, how does the inside of the side-plate look?
-
carbon outlaw
- Posts: 279
- Joined: Fri Jul 04, 2014 9:19 pm
Re: S&K mount part 2
have a look ..
- Attachments
-
- DSCN0917.JPG (156.99 KiB) Viewed 1227 times
-
- DSCN0916.JPG (198.78 KiB) Viewed 1227 times
-
- DSCN0915.JPG (193.71 KiB) Viewed 1227 times
Re: S&K mount part 2
Are the screws different lengths, if so will you mark them so they go back in the same location? The ends of the screws look like they were lathe trimmed. How ever you did it it is still well done.