Krag Rifle Project: https://www.icloud.com/sharedalbum/#B13GdIshaGPQJFF
Completed Krag Rifles: https://www.icloud.com/sharedalbum/#B135aVbMKvUA6Z
A few years ago I purchased a rifle with a shot out barrel and a stripped receiver with the intention of bringing them back. I purchased reproduction stocks, hand guards, various parts (thank you Grandpa), and I also purchased new criterion barrels for both. BR contributed a sight to one of the rifles also! The rifles were then sent off to Griffin & Howe for rust bluing following arsenal instructions from the time period. All the details are in this thread:
http://www.kragcollectorsassociation.co ... php?t=6777
Below is the instructions I provided to Griffin & Howe:
Griffin & Howe completed the job today (about 1 one year later) and sent these two photos ahead:RIFLES
US Model 1898 Springfield Armory 242668
US Model 1898 Springfield Armory 482609
OVERVIEW OF REQUESTED SERVICE
I began the restoration of the two US Model 1898 Krag rifles in the spring of 2022. The goal is to restore both rifles to an arsenal correct configuration as outlined in a 1907 US Ordinance Depot instruction. I have included the instruction for proper finish below — with added expertise and attention to detail provided by Griffin and Howe to bring them a cut above a standard issue rifle.
Both rifles have a new criterion barrel, walnut stock and hand guard (stained, inlet for the rear sight, and the clips were handmade). The rifles have been assembled with new reproduction screws and when required replacement parts. New old stock parts were generally selected as first choice — for example the bolt sleeves and extractors are new old stock.
Some parts between the rifles may not be interchangeable. For example the butt plates are not exactly the same size — the stock were fitted to each butt plate. Also the bands and swivels differ slightly.... I speculate this may due to different production year and manufacturer. They certainly are not as standardized as a modern AR-15. For this reason it may be best to not mix the parts of the two rifles.
Both rifles should be generally free of pitting above the stock line, but should be inspected and polished to correct. The butt plates and one rear sling swivel will need attention for some some pits and gouges — however, it should overall be minimal as both rifles are in excellent condition.
The front sight base on each rifle is new and cut to fit the dove tail. However, the front sight base was typically silver soldered into place — I have held off on the soldering as it may be easier to blue without them on. They will need to be soldered into place after the bluing. Also, the front sight blade channel will have to be filed some to fit the sight blades (they are very tight). I have placed the front sight blades, pins and protectors in a ziplock bag and envelope for assembly after bluing.
RIFLE FINISH
U. S. Magazine rifle, Cal .30, model 1898 and carbine model 1899
BLUE IN NITRE: Butt plate and cap, swivels and bands, trigger guard, front sight blade, and magazine cutoff (spring removed)
RUST BLUE: Barrel, front sight base (silver soldered on barrel after bluing), rear sight base, rear sight leaf and slide (do not allow acid into slide and sight screws), safety lock complete (do not allow acid in spring hole), receiver, side plate, loading gate, and magazine cutoff (if spring not removed - do not allow acids in spring hole)
POLISH: Bolt sleeve, extractor (polish to highlight color), rear sight leaf top (to highlight distance graduations), magazine cutoff side when in ON position
BLACK IN MOLTEN LEAD OR QUENCH IN OIL: Finger piece of trigger
BLACK IN OIL: All exposed screws, pins, and rivets.
CLEANED: All parts not enumerated
Reference included US Arsenal Refinishing Instructions from 1907.