Page 1 of 1
S&K mount part 2
Posted: Wed Dec 23, 2020 7:43 pm
by carbon outlaw
Got my scope mount finished ... I added a bracket so I could attached my S&K scope mount to the side plate ... I made the scope mount very solid ... Have a look ....
Re: S&K mount part 2
Posted: Wed Dec 23, 2020 8:00 pm
by FredC
Nicely done. No gap evident here. Must have been an optical delusion or maybe an optical collusion that made me think a gap needed addressing. Should be the most stable S&K mount around!
Re: S&K mount part 2
Posted: Wed Dec 23, 2020 10:39 pm
by butlersrangers
Attractive on the outside, how does the inside of the side-plate look?
Re: S&K mount part 2
Posted: Wed Dec 23, 2020 11:03 pm
by carbon outlaw
have a look ..
Re: S&K mount part 2
Posted: Thu Dec 24, 2020 2:31 am
by FredC
Are the screws different lengths, if so will you mark them so they go back in the same location? The ends of the screws look like they were lathe trimmed. How ever you did it it is still well done.