Using 7.62 Russian Brass in Dane
Posted: Thu May 26, 2022 6:11 am
I know some of our members use 7.62X54mmR (Russian) Brass to make cartridge cases for the 8X58mmR Danish Krag.
The Russian case is not only short overall, but is also smaller in diameter in the case head and body, than the Danish cartridge
Are these cases only a one-shot deal and then scrap? .... Or do they holdup for a number of safe loadings?
I have a small quantity of Norma and PPU 7.62X54mmR Brass in my 'odds & sods'. I've expanded the case necks to hold .323 cal. - 196 grain projectiles.
I've loaded the cases with 38 grains of IMR-3031, with the 8mm bullets seated for an OAL of 2.995". (The rounds feed and function through my Danish Krag action).
I will be testing these loads this week, weather permitting. I'm just curious about the longevity of this improvised brass, based on the experience of other KCA members.
The Russian case is not only short overall, but is also smaller in diameter in the case head and body, than the Danish cartridge
Are these cases only a one-shot deal and then scrap? .... Or do they holdup for a number of safe loadings?
I have a small quantity of Norma and PPU 7.62X54mmR Brass in my 'odds & sods'. I've expanded the case necks to hold .323 cal. - 196 grain projectiles.
I've loaded the cases with 38 grains of IMR-3031, with the 8mm bullets seated for an OAL of 2.995". (The rounds feed and function through my Danish Krag action).
I will be testing these loads this week, weather permitting. I'm just curious about the longevity of this improvised brass, based on the experience of other KCA members.