Page 1 of 1

Need Info

Posted: Sat Aug 06, 2005 2:58 am
by El_Guapo
I inherited a Krag from my grandfather just recently and I have found it hard to come by any information on the internet for my Springfield 1898. SN# is 168751. Anything about my gun would be appreciated. I am guessing everything is the way my grandpa got it except for the stock which has a rubber butt on it. I havesome pictures I can post later. Thanks

Re: Need Info

Posted: Thu Aug 11, 2005 12:10 am
by Rick_the_Librarian
Your Krag is an 1898 rifle and was probably manufactured in early 1899. Is it still in original condition (except for the buttplate)?

Re: Need Info

Posted: Thu Aug 11, 2005 5:51 pm
by Matt Evjen
Yes, I don't know much, but my grandpa replaced the butt plate for hunting. Everything else looks original. The wood assembly has the initials C.I stamped on it when I dissesemble it for cleaning. That is the only other writing I can see marked on it.

Re: Need Info

Posted: Mon Aug 15, 2005 1:04 am
by Matt Evjen
This is a picture I took of my krag.

img

Re: Need Info

Posted: Mon Aug 15, 2005 10:25 am
by Rick_the_Librarian
Matt,

Your Krag has been sporterized. The barrel has been cut down, the handguard is gone and the front sight is not original. It should make a good shooter, though. During the 1920s, these rifles sold for as little as a couple of dollars and it is very common to see them in that condition.

Just for the record, here is a picture of my Krags in original condition and I think you'll see the difference. The one in the middle is a correct carbine and is not cut down.

img


Re: Need Info

Posted: Mon Aug 15, 2005 5:28 pm
by Matt Evjen
Thanks for all the information. What is the average price for one of these today?

Re: Need Info

Posted: Mon Aug 15, 2005 6:49 pm
by Rick_the_Librarian
If you mean in original condition, anywhere from $500 to $5000. An 1898, the most common rifle, will be in the $500-1000 range. It never hurts to look the 1898 in the picture (the bottom one) set me back only $285. It had some surface rust and needed a part or two replaced but after a little TLC, it is one of my nicest rifles.

Re: Need Info

Posted: Tue Aug 16, 2005 1:27 am
by Matt Evjen
How did you get rid of the surface rust? This one has some splotches on it along the barrel and chamber.

Re: Need Info

Posted: Tue Aug 16, 2005 10:16 am
by Rick_the_Librarian
I used a teflon pad and a copper (not steel) brush and some CLP and kerosene (for the small parts). It took some elbow grease but the result was a fine rifle.